Electronics Forum | Fri Apr 20 08:41:56 EDT 2001 | jimlew
For those of you out there, like myself who are still using 2-d to measure paste ht, I have 2 questions. 1. Typically, what tolerance are you applying to your ht? +- 1 mil, or what? 2. Are you using metal squeegees, and if so, have you found that squ
Electronics Forum | Mon Oct 03 13:37:40 EDT 2016 | chabscan
I've been having some problems with my Quad 4C, it rejects some components after having pikced them up. I want to adjust the tolerances and test the pick up. I want to know if there is some way of testing the pick up without having to run my whole
Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Thu Jun 06 08:16:13 EDT 2002 | caldon
Jim- Sorry I can not offer advice on the Panasonic machine but do want to shed light on the Die and waffle pack issue. Take note that if the Die are loose in the pockets the balls or terminations could be damaged. The thin layer that the ball is atta
Electronics Forum | Mon Jul 16 13:54:53 EDT 2012 | markhoch
It's been a while since my MYDATA days, but let's give this a shot. Did you try putting the tool away and picking it back up? Make sure your Midas Head is cleaned and the tool is lubricated properly, then do a Center Base Leveling Calibration. (I t
Electronics Forum | Mon Jul 16 16:28:18 EDT 2012 | mikesewell
I'm somewhat frazzled by this one, not being too familiar with the MYs. Head is clean, tried different tools, same tool# from another MY, and have run the Centering Base Level Calibration to no avail. The component heights are correct and the par
Electronics Forum | Fri May 30 12:41:39 EDT 2008 | severs
I say that there is a market... The question is this: -How big is the market? -Is it worth going after? -Are you the person who can do it? Cost is everything to some people. There will always be a certain segment of buyers who will buy a product base
Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Wed Apr 28 20:57:22 EDT 2021 | stephendo
It will be tough to get a good line for that cost. You might want to start by looking at Mydata and Juki for the machines. Ekra for the screen printer and Heller for the oven is where you might want to start. If you have not already you might want
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
